Latest activity
Live updates
-
Smudgemanuk replied to the thread Driveshaft Clunk??.AHH! I thought we might finally be getting somewhere! -
Smudgemanuk replied to the thread Trouble finding correct wheel speed sensor..Did you match the part numbers when buying the part? Find the part you are looking to replace on RealOEM.com and then use that part...
-
KKwinterowd posted the thread Trouble finding correct wheel speed sensor. in Z4 & Z4 M Roadster & Coupé Knowledgebase.I went to change my LR wheel speed sensor and found the alignment fins in the connector is different than the OEM. 2002 2.5 Roadster.
-
Althulas replied to the thread Codes help.In the AI responses it did give a few hits on similar issues, give it a try at least a starting point of things to look at. -
Althulas replied to the thread Codes help.In the same ‘conversation’ I inputted your other two codes BMW Code 76 (Speed Sensor, Signal Interference) indicates that your ABS/ASC...
-
Althulas replied to the thread Codes help.2. Wiring or Connector Issues Corroded pins at the ABS module block or a break in the CAN bus wiring harness can cause data loss. [1, 2...
-
-
Althulas replied to the thread Codes help.I googled your codes and got… A BMW Z3 code 94 (ASC/DSC: CAN data fault from DME/DDE) means your traction control module (ABS/ASC) has...
-
-
NNeil Wilson replied to the thread Rear dif mount bush..Picked my car up from local garage today having had the new AKG polyurethane bush fitted, mechanic said it was easy enough to fit, I...
-
So first off no lights no issues driving/braking just thought I would try my recently acquired code reader, pulled these that will not... -
-
ExMX5owner replied to the thread Love the seaside . . . Hate the seaside . . ..Dirty great big bats, wing span of about a meter, make a god awful din at night, and poo purple, and its usually runny and gets really... -
Harris replied to the thread Z3 A Pillar Leak Repair Advice Please.My understanding is that A and B drain down C which comes out of the plastic near the door hinges. -
BBigM52GuyLol replied to the thread Driveshaft Clunk??.I replaced my guibo and was certain to install in the correct orientation, and it didn’t fix or even quiet down the clunk noise...
-
Randall M replied to the thread 1998 Z3 1.9l Autocross Build.Replaced the wanky, non-protective plastic bits with honeycomb grill mesh. This completes my fog lamp delete, as well.
-
-
colb replied to the thread George from Abergavenny.Met George today when he paid a visit to the Zedshed Cymru here in Newport after joining our South Wales Whats App Group. Good look...
